AeroTexNon-woven geotextile manufacturer

Geotextile under pavers: walkways and patios.

Interlocking pavers stay flat only as long as the base under them does. A layer of non-woven geotextile under the stone base stops it sinking into the soil, so the pavers don't dip, rock or grow weeds in the joints from below.

By AeroTex, non-woven geotextile manufacturer, Seremban · Updated 18 November 2026

AeroTex non-woven geotextile laid between kerbs under the stone base of a paver walkway beside a playground
An AeroTex customer's paver walkway: fabric first, then the stone base, with the pavers stacked ready.

The short answer

Dig out the path, compact the soil, lay non-woven geotextile between the kerbs, then build the crusher run base on top, add a thin sand bed and lay the pavers. For walkways and patios, 130 gsm (ATX20) is the usual grade; paved driveways and car parks need a heavier grade.

Where the fabric goes under pavers.

The geotextile goes on the compacted soil, under the stone base. It keeps the base from mixing into the soil. The sand bed and pavers sit on top of the base, not on the fabric.

  • Compacted soil
  • Non-woven geotextile
  • Crusher run base, compacted
  • Sand bedding
  • Interlocking pavers
Cross-section of a paver walkwayCompacted soil, a white geotextile layer, a crusher run base, a thin sand bed and interlocking pavers on top, held by kerbs.PaversSand bedCrusher run baseCompacted soilGeotextile
Cross-section, not to scale.

How to build it, step by step.

  1. Mark out and dig

    Dig out the path or patio deep enough for the base, sand bed and paver thickness. Remove roots and soft soil.

  2. Set the kerbs

    Fix the edge kerbs first so the base and pavers have something to hold against.

  3. Compact the soil

    Compact the bottom with a plate compactor and keep a slight fall so water runs off the surface.

  4. Lay the geotextile

    Roll the fabric between the kerbs, turned up against them. Overlap joins by 300 mm.

  5. Build the base

    Spread crusher run on the fabric and compact it in layers; walkways and patios typically use about 100 to 150 mm.

  6. Screed the sand bed

    Spread and screed a thin, even layer of sand, typically 25 to 40 mm. Don't compact the sand before the pavers go down.

  7. Lay and compact the pavers

    Lay the pavers in your pattern, cut the edges, then run the plate compactor over them.

  8. Fill the joints

    Brush fine sand into the joints and compact again until the joints are full.

How much fabric do you need?

ATX20 rolls are 2 m wide, so most paths take one strip run along the path. For patios, side-by-side strips overlap by 300 mm.

Paths: one 2 m strip turned up against the kerbs, plus 5%. Patios: 300 mm overlaps and 5% for cutting; a 100 m roll covers about 170 m².
Job2 m × 100 m rollFabric needed
Path up to 1.7 m wide, 20 m long1 rollabout 21 m of roll
Path up to 1.7 m wide, 50 m long1 rollabout 53 m of roll
Patio 30 m²1 rollabout 37 m²
Patio or plaza 100 m²1 rollabout 124 m²
Plaza 200 m²2 rollsabout 247 m²

Wider paths and patios take strips side by side. For other sizes, use the roll calculator.

Which grade under pavers?

Pick the grade for what goes over the pavers.

Walkways, garden paths, patios
130 gsm (ATX20), made in Seremban and in stock.
Park paths and plazas with maintenance vehicles
150 to 190 gsm (ATX30, ATX40), to order.
Paved driveways and car parks
210 to 250 gsm; see the driveway guide.
Roll sizes
ATX20: 2 m × 100 m and 2 m × 250 m, from a single roll.
Catalogue
Download the AeroTex catalogue (includes the data sheet). Test reports on request.

Why pavers sink and rock.

Uneven paving usually goes back to the base, not the pavers.

  • Pavers laid on sand over soil · with no stone base, the sand pushes into the soil and the pavers dip
  • No fabric under the base · the crusher run slowly mixes into the soil, especially on clay
  • Sand bed too thick · thick sand moves and the pavers rock
  • No kerbs or edge restraint · the pavers spread outwards and the joints open
  • No fall · water sits on and under the pavers

Fabric under the base, or under the sand?

The main place for the fabric is under the crusher run base, on the soil. That is what stops the base sinking.

Some installers also lay a strip of fabric over the joints between the base and the sand bed, so the sand can't wash down into the stone. That is optional; the layer under the base is the one that matters.

Paths our customers have built.

AeroTex under the stone bed of a paver walkway beside a playground
Paver walkway in a park
AeroTex under a new gravel footpath in a park
Gravel footpath in a park
AeroTex under pebbles and stepping stones in a home garden
Garden path with stepping stones

Paver questions.

Do I need geotextile under pavers?

On most Malaysian soils, yes. It goes under the crusher run base and stops the base sinking into the soil, which is the main reason pavers dip and rock over time.

Where does the geotextile go under pavers?

On the compacted soil, under the crusher run base. Not directly under the pavers and not inside the sand bed.

What gsm geotextile under pavers?

130 gsm (ATX20) for walkways, garden paths and patios. Paved driveways and car parks use 210 to 250 gsm.

How thick should the base be under pavers?

For walkways and patios, typically about 100 to 150 mm of compacted crusher run, plus 25 to 40 mm of sand bedding. Driveways need a deeper base.

Does geotextile stop weeds between pavers?

It stops weeds growing up from the soil below. Weeds in the joints usually start from seeds blown in on top; keeping the joints full of sand helps.

Can I lay pavers straight onto geotextile?

No. The fabric goes under a compacted stone base. Pavers need the base and sand bed to stay level.

Where can I buy geotextile for pavers in Malaysia?

AeroTex makes ATX20 in Seremban and sells from a single 2 m × 100 m roll, with nationwide delivery. Send the path or patio size on WhatsApp for a price.

Laying pavers? Send us the size.

Tell us the path or patio size and the delivery location. We reply with how many rolls you need and today's price.

WhatsApp +60 12-979 8233
This guide describes common practice for paver walkways, patios and plazas. For paved roads and heavy-duty car parks, follow the engineer's design. More guides: all applications · aerotex.my
AeroTex logo© 2026 AeroTex™ Non-woven Geotextile. Made in Malaysia. aerotex.my